Mississippi Pot Roast

Mississippi Pot Roast

Quick answer

Total time
490 min
Level
Easy
Servings
8 servings
Ingredients
7

About this dish

The more pepperoncini you add, the spicier and tangier the roast and gravy turn out; this one uses 6, and you can go as low as 2.

Read more

The two seasoning packets alone make it fairly salty, so for a milder roast use half of each.

Ingredients

servings

Convert cups, spoons and grams

Instructions

6 steps

Stops the screen from turning off while you cook.

  1. 1

    Put the chuck roast in the slow cooker and sprinkle the au jus mix and the ranch mix evenly over the top.

  2. 2

    Set the butter on top of the meat, tuck the pepperoncini around it and pour the 60 ml of water down the side.

  3. 3

    Cover and cook on LOW for about 8 hours.

    The roast is done when it pulls apart on its own as you press it with two forks.

  4. 4

    Move the roast to a board, shred it with two forks and pull off any large pieces of fat.

    Lift out the pepperoncini too.

  5. 5

    Strain the liquid from the cooker into a saucepan, skim off the fat on top and bring it to a simmer over medium-high heat.

    For a thick gravy, whisk in the 1 tablespoon of flour slowly and simmer briefly until it thickens. For a thin sauce, skip the flour.

  6. 6

    Return the meat and pepperoncini to the cooker, pour the sauce over and toss to coat.

    Taste before adding any salt, then serve over mashed potatoes or rice, or pile onto rolls.

References checked

These references were consulted when this page was prepared or corrected. A source check does not mean the recipe was independently kitchen-tested.

Use-up ingredient planner

Turn these ingredients into two more meals

The overlap excludes basic seasonings. Open the next recipe and your selected dishes will stay with you.

Tips

If you use cubed stew beef instead of a whole roast, check it at around 7 1/2 hours, because it finishes sooner.
In an Instant Pot, raise the water to 180 ml, cook at high pressure for 60 minutes and let the steam release slowly before opening.
Edited by Charim Team